DENTSPLY Vulcan Box A-130 Betreibershandbuch

1Owner & Operator's ManualDescription PageSafety ... 2Installation ...

12SETUP:The Vulcan furnace goes through a self test that lasts for 4 to 6 seconds each time that power is applied. After thetest, the display will sh

13TEMPERATURE ADJUSTMENT/CALIBRATION:Every VULCAN furnace is calibrated in the factory at 1000°C. Under normal use the furnace should not requirecali

14ERROR CODES:Err codes can be cleared from the display by turning the front panel power switch off and then on again. Code Description Possible Cau

15 ACCESSORIESDESCRIPTION PART NUMBERTongs; 25cm (10") Stainless Steel 9390014Tongs; 30cm (12") Stainless Steel 9390015Tongs; 36 cm (14&quo

16WARRANTYWARRANTY: Except with respect to those component parts and uses which are hereinafter described, DENTSPLY NeyTech warrants this furnace to b

2 SAFETY• Never operate furnace in close proximity to combustible materials or place materials on top of the furnace.• Caution: To provide continue

3 FEATURES- High Performance / Hybrid MuffleLonger life and more durable than fiberFaster heating and faster cooling than firebrick- Wide operating t

4 INSTALLATION INSTRUCTIONSUNPACKING CAUTIONS:Carefully unpack and remove the furnace from its shipping carton. Save the carton and other packingmat

5 OPERATIONSRUNNING A PROGRAM:The furnace has 9 three stage programs and one single temperature hold program. The furnace is sold withthe program pa

61100°C 12:30H 1Temperature keydisplays the currentprogram's temperaturesin degrees. Press oncefor T1 (temp 1), twice forT2 (temp 2), and

7PROGRAMMING:The furnace increases productivity and reliability for the operator because cycles or programs can bepreprogrammed and operated automatic

8parameter will be displayed again.• The Hold key operates the same if pressed during the operation of a program with the followingexception. Any new

9 SPECIFICATIONSPARAMETER- Temperature Range: 50°C (122°F) - 1100°C (2012°F) / 1° Resolution- Hold Time Range: 0:00 - 99:59 (hours:minutes) / 1 Min